Forums » Handloading

Kinetic Bullet Puller

    • 21 posts
    February 25, 2010 1:36 AM EST

    Hi Guys,

    Do you know any make of kinetic bullet puller that will take .416 Rigby cases? My Quinetics Magnum Model Kinetic Bullet Puller is too small for the Rigby case. Are there any other ways of pulling the bullet from the Rigby case?

    Many thanks, Shivashankar

    • 22 posts
    February 25, 2010 2:37 AM EST
    I've used my R.C.B.S to pull .416 slugs in the past. It's the hammer type model. Cheers, Doc.
    • 52 posts
    February 25, 2010 11:21 AM EST

    I use a hammer type model too and have pulled bullets from my 450/400, that should work. Several companies here make a similar model. Here is a link to one www.midwayusa.com/viewproduct/ You might just want to double check with them though.

    • 21 posts
    March 20, 2010 4:54 AM EDT
    Thanks for the tips guys. Midwayusa confirmed that only RCBS bullet puller is able to handle .416 Rigby size cases and I ordered one. I tried it after it was delivered and it worked just barely. I found the Hornady .416 Rigby brass to be too soft at the neck and buckled while seating the bullets. May be once fired brass will be more stronger.
    • 22 posts
    March 20, 2010 7:20 AM EDT
    G'day Doc. You may ( or may not ) find that chamfering and de-burring the inside of the case neck prior to bullet seating will reduce the incidence of crushing the cases. A simple chamfering tool ( R.C.B.S ) is available that does both the inside and outside of case necks. I've found a lot of brands of cases brittle when new, this tool takes the square edge of the inside of the neck and helps the pill slip in easier. Or you may have just got a dodgy lot of cases !
    • 3 posts
    March 20, 2010 10:23 AM EDT
    just one question Doc does it crush the case as the bullett is just starting in or is it when you go to seat it for the full lenght ie the bottom of your stroke don
    • 21 posts
    March 20, 2010 4:04 PM EDT
    It used to happen at the end of my upward stroke when the bullet is fully seated. I had set the bullet seating die of my Hornady custom dies for a slight crimp to prevent the bullet moving deeper into the case because of recoil. Then I undid this and as long as I seat the bullet very slowly, the cases do not buckle. I haven't tried reloading once fired cases as yet. I will let you know what happens.
    • 10 posts
    November 3, 2010 2:17 PM EDT
    Check tis websit i has good info www.cowboyhunter.com
    • 21 posts
    November 9, 2010 5:56 AM EST
    The problem I experienced while reloading my .416 Rigby using Hornady Dies disappeared when I started to use Lyman dies. The culprit was the expander ball. The Hornady one measured only .413 and the Lyman measured .415. Despite the best possible case preparation, the neck was too tight and that is why the case was buckling at the neck when bullet was seated. There is nothing wrong with the cases.